The added parameters in the Global section are as follows:


isM  = Inhibit SW-1000 MIDI In - when ON it disables the ability to
receive MIDI via the 44 way cable - MIDI has to come from the socket.

cc7y = enable MIDI volume (cc7) to control the volumes of Y outputs -
(for Midi IN SOCKET only - not via 44 way)

cntP = controller send on prog select - the stored values for the selected controllers are sent to the cards when a
new program is selected.

-----------------------------------------

Revision notes for Plugstation .syx files:

plgs1565	28/11/2004	now recognises and sets defaults for new PLG150-AP card

plgs1560        29/11/2003      fixed SysEx response to chan / part changing

plgs1554	26/08/2002	now recognises and sets defaults for new PLG150-DR & PLG150-PC cards

plgs1552	03/11/2001	cc10 will control balance of plg cards to the Y board along with cc7 if "cc7y" is set

plgs1550	20/10/2001	by setting "cntp" to yes in global menu, the controller number & value set in the individual
				PLG card menus will be sent to each card whenever programs are changed & at power up.

plgs1548	20/10/2001	by setting "cc7y" value to yes in global menu, cc7 will control volumes of plg cards to the 
				Y board. Applies only to cc7 messages sent to the MIDI input on the back of plugstation.

plgs1546	10/10/2001	fixed problem where VL card could only be used in slot #4 - all cards now work in all slots

plgs1545	03/09/2001	fixed problem with large bulk dumps to AN and VL cards not always getting through

plgs1542	01/09/2001	fixed problem with "waiting for computer" not always being acted on when enabled
